ICMP primarily carries error and control messages with #Internet Protocol (IP) datagram over a network in the case such as unavailable service and unreachable host.
Command ping, exists in #windows and Linux#, utilises ICMP to detect the response time and time to live (TTL) of the target destination to the source.
The process of forwarding the packet from its received port to the outgoing port is called switching. Despite the naming, Router will immediately drop the packet when it can’t figure the destination in its routing table maintained by itself. Otherwise, it will simply modify the destination Media Access Control Address (MAC) (the next-hop, can be another Router or the final destination) in the packet without touching the IP Address which defines the final destination. Though the primary forwarding decision will be based on the Routing Table# or routing information, assuming there is a mapping of logical address to its interface or port. If there is no path defined in the routing table to where the packet should be forwarded to, Router will redirect it to a default route if set (usually 0.0.0.0 in IPv4 Address and ::/0 in IPv6 Address), or simply discards it and sends Internet Control Message Protocol (ICMP)# Unreachable message to the source. Additionally, we can divide a physical interface into at most 65,535 logical interfaces using the command interface {interface-name} {interface}.{subinterface}. This is particularly useful in Virtual LAN (VLAN) routing.